Mods for the IC-W32E tranciver by SM6VIT Rickard. 970703 The IC-W32E tranciver is a funny little radio that can do alot more than it does when it leaves the factory. --------------------------------------------------------------------------- On my radio i have RX on these FQs: AM 108-136MHz FM 136-200MHz 300-400MHz 400-600MHz 600-1000MHz Now these are the FQs that is shown in the display so if U got a FQ far away from ham bands that dont work that is OK. I havent tested the sensitivity on different FQs so that is for U to do. Now to the really fun part, the TX FQ can be these: FM 108-136MHz 136-196MHz 362-400MHz 400-492MHz The further away from ham FQs U use the lower the output power will be. And remember that your antenna might not be built for all these FQs. --------------------------------------------------------------------------- To use extended RX FQs U have to do like this. While pushing [SQL] and [BAND] turn on power. It is as easy as that at least on my radio. This can be diffrent on some radios that are sold in contrys where it is illegal to listen to other than ham FQs. --------------------------------------------------------------------------- WARNING! WARNING! WARNING! WARNING! WARNING! WARNING! Your warranty may be expired if U take your radio to pices! And most likly it is illigal to have a TX expanded radio in your contry! --------------------------------------------------------------------------- For the TX expantion it is a little bit more dificult. U have to solder in your radio. First U have to remove D523 (4) on the logic unit. Remove battery, remove 6 screws on the metal plate under the battery, lift up the metal plate and there is the logic unit. It shoult look someting like this. _____________________________ |_ ic341 | ic201 O_| o | 1 5| 2 3 |__ 4 | __|__ ic5 | |diode| flat cabel o O | |_____| HHHHHHHHHHHH _| | | ______________________________| 1=D528, 2=D52, 3=D525, 4=D523, 5=D531 All diodes have 3 legs! Then push for RX expand. --------------------------------------------------------------------------- Crossband repeater function is possible on the IC-W32E but it dosent work on my radio. It depends on witch CPU U have. But U could always try it. Set VHF and UHF FQs, turn tone squelch on, turn lock function on, turn off the tranciver, push [SQL], [MAIN] and [BAND] keys and turn power on. --------------------------------------------------------------------------- That was all I had for now but if I find someting more I will write a new instuction. To contact me try E-mail: sm6vit@hotmail.com sm6vit@swipnet.se packet: sm6vit@sk6yw.o.swe.eu tele: +46 (0)31-775 26 26, +46 (0)704-97 19 05 Snail mail: Rickard Berging Paradisg. 14 413 16 Goteborg SWEDEN ---------------------------------------------------------------------------